Bosch TS1002 Table Saw Rear Outfeed Support Extension
|
List Price: Category: Tools See more product details |
|---|
(Click here)
Tools and Hardware Reviews of Bosch TS1002 Table Saw Rear Outfeed Support Extension
Customer Review: The other great addition to a great saw!
Summary: 5 Stars
I had the saw for about a year when I bought this extension and the rear one.
You may have read this same review for the side extension but here goes anyway.
The saw has tapped holes ready for Both of them, they mount independently and work very well.
The illustration shows them both in a with rails in a vertical position which makes hard for a left handed person to visualize how they support the work. Of course for the less challenged you could automatically tell that they were mount to the underside of the table and slide out for use. My brain was trying to see how these legs could support it from the floor...duh!
Anyway, if you work alone (which you shouldn't of course!!!) they are a godsend.
Customer Review: It works great for me
Summary: 5 Stars
I have no idea about what these other people are writing about, I just installed the rear extension right out of the box and it not only fit great, , but it worked wonderfully. Customer Review: Must have!
Summary: 5 Stars
This is a must have accessory for your Bosch table saw; easy to install and use. Customer Review: It rubs on the Bosch 4100 Saw, and hits the digital read out
Summary: 3 Stars
Excellent idea, but it rubs on my new 4100 Bosch Saw, and is scratching it pretty good. Also, when the support is closed, it will hit the digitial carriage (read out display). If you want to dock it (magnetically secure) the display you have to pull out the support a bit. Again, I like the idea, but it needs a lttle refinement for the fit on the actual table saw. Customer Review: mike in maine
Summary: 3 Stars
After reading some of the poor reviews for this product I had some reservations.When I unpacked and assembled the extention I soon discovered the problems others had described.1st the miter guide slots don't align with the notches in the extention.2nd the sliding rails are too far apart, one owner had elongated the mounting holes to address this.The actual problem is in the illustrations in the instructions! The pictures of the model 4000 saw and the 4001 saw are reversed.Simply mount one bracket facing outward[the one with the lock knob]and the other facing inward,as pictured for the model 4001,and the extention fits and operates smoothly! Perhaps BOSCH should correct the instructions instead of agreeing they had made a manufacturing error to appease a dissatisfied customer. I hope this helps others who encounter this problem.