Bosch TS1007 Dado Insert
|
List Price: Our Price: $12.40 You Save: $4.88 (28%) Availability: Usually ships in 1-2 business days Category: Tools See more product details |
|---|
Tools and Hardware Reviews of Bosch TS1007 Dado Insert
Customer Review: Info on how to use dado Insert
Summary: 4 Stars
Dado insert was functional. It fit properly. To use a 13/16" dado stack with this insert on your saw you need to do this. (Per Bosch Tool customer service)
Thank you for writing Bosch Power Tools. When mounting dado blades on
the Bosch 4000 table saw, follow this procedure which was omitted from
the owners manual. This saw will handle up to a 13/16" wide dado blade.
Remove both blade washers from the arbor shaft. Install & use the Outer
washer as the Inner washer, than[sic] mount your dado blade set, than[sic]
install the lock nut. An outer washer is not needed for a dado set. This
procedure will provide proper spacing of your dado blade set. Changing
blades can be a bit tight, but if you insure the blade is elevated to it's
maximum height you shouldn't have any problem. The reason for this is
because the dust containment shroud is rather close to the blade to
contain saw dust from blowing all over the place. If you have any further
questions, please write back.
Customer Review: It works fine
Summary: 4 Stars
It set in snug and adjusts flush. No complaints, cheap and it works fine with my Freud Dado stack. It's not for wide stacks but that is a good reason to go out and buy a 14" "shop" table saw.Customer Review: Dado Insert No. TS 1007 for Bosch Table Saw
Summary: 5 Stars
This is a metal dado cutter insert to allow you to safely make dados using a Bosch Table Saw. It is bright red, making it easy to locate when you set it somewhere, and mine required no adjusting to make it flush with the saw table surface--it has four set screws to adjust the height. No one could beat Amazon's price of $9.74 and since I ordered it with the saw there were no taxes or shipping expenses. I ordered it on January 30, Amazon quoted a delivery by February 14, and I received it before February 10. This accessory works great and you really must have it if you are going to do any dado work with your Bosch saw.Customer Review: Second one works fine
Summary: 3 Stars
Well, the first one I received was bent -- laying it face down on the table top, it would rock considerably. If adjusted so the front and back edge were in line with the table, it was high in the center. I figured that would probably throw my cuts off, so I just shipped it back. Amazon had a flat replacement at my door a few hours after I managed to drop the old one in the mail. The replacement works great, and I'd probably rate it 4 stars if the first one hadn't been bent. Also, considering that the manual for the saw itself says very little about mounting a dado stack, it might be nice if the insert gave you some more info. I had to email Bosch tech support to get the secret for getting beyond 1/2".Customer Review: Don't bother
Summary: 1 Stars
After struggling somewhat with fitting it and the dado blade to the drive, I decided it would be better to use it as a good template for my own homemade Insert.